One Stop A-Frame (OSA6135, 7247, 7263,8756, 8763)

• ***CALL FOR FREIGHT QUOTE***Sturdy structure, designed to eliminate any risk of slabs tipping over.
• Slabs are placed on a special rubber profile and secured with 4 ratchet securing bars.
• Contains an extra storage section in the center that is ideal for storing tools.
• Frame features 2 eyelets to be picked up by an overhead crane.
• Built in brackets on all underneath sides for forklift transport.
• Four removable casters included

The correct way of tightening the rubber lined securing bars for the Abaco One Stop A-Frame.

The ratchet hook needs to run under the bar and back around to the tie down point. This will ensure that the rubber lined securing bar stays in position and does not lift up when tightening.

It is recommended that the securing bars stand level with, or taller than, the slab itself. The securing bars will not work to their full potential if your material does not stand within the height of the bars. This is because the straps are not as strong as the ratchet securing bar.

Please Note:

The securing bars are not to be used when carrying full slabs of material. To secure a full size slab on the A-Frame, use only the straps.

Forklift Users:

Always make sure your forks are fully inserted into the A-Frame before lifting. This will ensure a proper and secure lift.

The correct way of removing the casters:

Make sure the load is fully secured before removing the casters.

Lift the A-Frame off the ground high enough for you to have proper access to the casters.
With one hand holding the caster, use your other hand to pull out the pin. Please place the caster in its holder. If you remember to do this, you will never have to worry about losing your casters.